Page 8 of catalogue Turning milling center of Index-Werke GmbH & Co.KG

RatioLine R200

The magazine – all Tools on board
Two separate shuttle units independently supply the two motorized Milling spindles with the tools required in each case from the tool magazine. With a maximum of 120 tool pockets, the R200 has a large tool set. Typical chip-to-chip time of 4 seconds contributes to minimizing secondary processing times. 3. 1. Transverse shuttle for removal of tools from chain magazine 2. Handover from transverse shuttle to longitudinal shuttle via double gripper 3. Loading position of tool for milling spindle

2.

1.

At a glance • 80/120 tool pockets (HSK-A40 holder) • Minimum load cycles; typical chip-to-chip time of 4 seconds • Simultaneous and independent loading of both milling spindles possible • High degree of functional reliability due to standard tool magazine with chain design Reducing secondary processing time: While machining is performed on the main spindle, the lower milling spindle can load a new tool, protected from falling chips and coolant. That results in higher productivity and improves process reliability.

8