Page 10 of catalogue Miniature profile rail guides of SKF Linearsysteme GmbH

Lubrication
The relubrication intervals depend on the environmental conditions and the magnitude and type of load! As the manufacturer is not familiar with the respective individual operating conditions, only tests carried out by the user or close observation can provide certainty about the appropriate relubrication intervals. SKF miniature profile rails are pregreased and are thus ready for use when delivered. The individual carriages can be relubricated through lubrication holes at the faces. Here, the relubrication intervals depend on the distance travelled as well as the cycles and environmental conditions.
Order designation VM LLM 12 Size Standard 7, 9, 12, 15 Wide series 9 W, 12 W 15W

VM LLM 15

Carriages Mounting and dismounting
For dismounting the system premounted by SKF, please observe the following instructions:
B

• Remove the end-stop B from the rail. • Position side 1 of the mounting rail A to the rail 2 so that there is no misalignment or gap between rail and mounting rail. • Slide the carriage C from the rail to the mounting rail and keep both rails in position while doing so. For mounting the carriage onto the rail, please proceed in reverse order. Attention: Please always use the enclosed mounting rail as the ball retention inside the carriage is not guaranteed otherwise.

A 2 1

C

10