Page 9 of catalogue Inductive sensors of Rechner Industrie-Elektronik GmbH

MOUNTING
The material and version-dependent maximum torque should be taken into consideration in order to prevent damage to the threaded sleeves when mounting. The values listed in the table are based on the use of the Nuts supplied with the Sensors.

Housing Material
Thread
M 5 x 0.5 M8x1 M 12 x 1 M 18 x 1 M 22 x 1.5 M 30 x 1.5 M 32 x 1.5

PVC
1.5 Nm 12 Nm -

PA 6.6
1 Nm 1.7 Nm 6 Nm 8 Nm 13 Nm

P TFE
0.2 Nm 0.5 Nm 1.4 Nm 2.5 Nm 3 Nm

Brass
16 Nm 28 Nm 32 Nm 82 Nm 150 Nm

Stainless Steel
1.5 Nm 4.5 Nm 25 Nm 60 Nm 84 Nm 200 Nm 230 Nm

Due to the permitted thread tolerances specified in German standard DIN 13, the maximum screw-in length for threaded sensors should be taken into consideration. Depending on that the length of the threaded block for screwing in Proximity sensors should not exceed the following dimensions. In the case of larger threaded blocks we recommend Drilling a blind hole in order to adhere to the maximum screw-in length.

Thread: Screw -in length max.

M 5 x 0.5

M8x1

M 12 x 1

M18 x 1

M 22 x 1.5

M 30 x 1.5

M 32 x 1.5

All specifications are subject to change without notice. (05/2004)

3 mm

6 mm

8 mm

12 mm

12 mm

12 mm

12 mm

TECHNICAL TERMS
Unless otherwise specified technical data is as follows: +24°C, UB = 8 V DC for IAS-30; UB = 24 V DC for IAS-10 and IAS-20 and UB = 230 V AC for IAS-60. Operating sensing distance / Sa Within the operating sensing distance the sensor operates reliably taking in to account all the possible tolerances. It lies between 0 and 0.81 x Sn. Power up time delay The time the sensor needs to be ready for operation after connecting the operating voltage. It is in the milliseconds range.

RECHNER Industrie-Elektronik GmbH • Gaußstraße 8-10 • D-68623 Lampertheim • Tel. +49 (0) 62 06 50 07-0 • Fax +49 (0) 62 06 50 07-20 • email info@rechner-sensors.de • www.rechner-sensors.de

9