Page 6 of catalogue Flow sensors of Rechner Industrie-Elektronik GmbH

...and INSTALLATION
When mounting the sensor in the corresponding pipeline one has to make sure that the complete sensor tip is surrounded by the medium that is being monitored.

Pipe mounting in the cross-section fig. 5

RIGHT

WRONG

For the dimensions please see page 9...17. For mounting and fixing a spanner with JS 27 is necessary Thanks to the special design the whole sensor can be rotated to any position from the front part of the cable exit after mounting and sealing. This allows an optimal alignment of the cable as well as the display head
All specifications are subject to change without notice. (03/2006)

Wiring of the Flow Sensors should be separated from heavy conductor lines as inductive peak voltages can destroy them despite the integrated protective circuit. For the female connectors please see page 18.

ADJUSTMENT, DISPLAY,...
The adjustment of the „...S“ version can be made by means of a 270° potentiometer. When the adjusted switching point is achieved the LED display changes colour from green to red or reverse and there is also a change of the switching state of the switching output (NO). For the „...IL“ version the measuring values are shown by means of a back-ground illuminated LCDdisplay. A 16bit micro controller with a 14bit A/D transducer and a 12bit D/A transducer take care of the necessary operation speed and precise measurement.

6

RECHNER Industrie-Elektronik GmbH • Gaußstraße 8-10 • D-68623 Lampertheim • Tel. (0 62 06) 50 07-0 • Fax (0 62 06) 50 07-36 • e-mail: info@rechner-Sensors.de • www.rechner-sensors.de