Page 7 of catalogue Flat tile of Dachziegelwerke Nelskamp GmbH

Shed roof tile
Shed Roof tiles should be fastened to the furring (see detail verge). Size sheets can be downloaded from the Internet or on the data service CD
itch of p n ro go in mm end dep 330 0 to 9 from

Aeration and ventilation in steep roof
1 Eaves fresh air element 2 Copper roll/Alu roll 2000 3 Clay dormer ventilator with fitted screen vent cross-section ~ 20 cm2 3 1
90° 60° 70° 80° Counter-laths Underlay/undercover sheet Eaves fresh air element

2

Ridge raised by ~ 1 cm

Aeration/venting

of mm th wid 340 o m fro ide t s rge ve

90° 80°= RP 10° 70°= RP 20° 60°= RP 30°

• • • • • • • •

maximum lath size of 330 mm minimum lath size of 90 mm maximum lath size of 310 mm minimum lath size of 90 mm maximum lath size of 290 mm minimum lath size of 90 mm maximum lath size of 270 mm minimum lath size of 90 mm

1) The vent cross-section at the eaves should be at least 200 cm2/m of eaves. 2) The vent cross-section at the ridge or crest should be at least 0.5‰ of the total corresponding roof area, though at least 50 cm2. (according to DIN 4108-3)

Installation instructions for alu base tile with single step/walking grid tile
Of stainless steel/aluminium. No supporting laths needed! Fastening to supporting lath: Aluminium tile fastened to lath with 2 Screws (V2A screw included)
Processing acc. to DIN 18160-5 Article ≤ 45° > 45° Walking grid every every tile row of tiles row of tiles Alu base tile every every w step tile row of tiles row of tiles

Storm Clips
No. 435/103 30 x 50 V2A No. 435/104 40 x 60 V2A

No. 409/008 75 x 38 V2A According to professional standards, we can supply storm clips for a simple and effective protection against wind suction. They can alternatively be clipped to the laths or knocked into the laths. Resistant to corrosion through stainless steel wire 1.4301 (A2) or ZIAL® coating (corrosion protection).

Roof lath 2 x fastening in the counter-lath

tested to DIN EN 516

Mansard and pent roof tile
The same applies for alu pantiles with snow rib or round wood holder, whereby the max. support spacing should not exceed 90 cm. For higher demands you should reduce the support spacing.

A

Installation instructions for universal alu step
A chase is made in the head and foot interlocking joint of the gutter tile using a right angle Grinder with diamond wheel to lead through the stainless steel suspension hinge. Hang the alu mounting bracket in the throat of the gutter tile so that the two rubber profiles with the lower end of the mounting bracket lie on the roof lath. The rubber profiles must rest where the gutter tiles overlap.
Installation instructions on delivery and can be downloaded from the Internet or on the data service CD Step Mounting bracket

C

B

Size sheets can be downloaded from the Internet or on the data service CD

F
E

Stainless steel suspension hinge can be adjusted for roof pitches from 0° - 60° tested to DIN EN 516

On the NELSKAMP data service CD or as a download on the Internet from www.nelskamp.de • Product specifications • Laying instructions • CAD data
Subject to technical changes. The dimensions are planning figures and should be checked before laying.

D