Page 3 of catalogue Eddy current sensors of Prüftechnik Dieter Busch AG

EDDYSENSOR
System description
The EDDYSENSOR is a simple yet complete single-channel eddycurrent testing equipment. The EDDYSENSOR consists of a minimum configuration of two units* with a third optional unit* in a table-top housing. The minimum configuration is made up of the Front-End Unit (FM1030F3 and FI 1030BA) and the Power Unit (PM 1040FE and PI 1040BA) where the back module of the Power Unit is supplied already built into the LAB 1004 housing for safety reasons. The optional unit is the Delay Unit (DM 1050F and DI 1050BA) that can be included for paint marking, warning and/or sorting.

Table-top housing for up to 3 modules
showing bus board and slots for modules.

LAB 1004

The housing and bus board together with the plug-in modules form a complete unit that can be used either as a table-top device or built into an electrical control cabinet. The back module of the Power Unit is supplied already built into the housing for safety reasons.
Housing 235.4 mm 9 1/4"

140.00 mm 5 1/2"

14 1/8" 358.5 mm Slots for modules Bus board

* Each unit consists of a front module and a corresponding back module, each with its own identifying number. 1