Page 2 of catalogue Distance sensor of SensoPart Industriesensorik GmbH

.

Technical data (typ.)
Distance measuring devices
FR 90 ILA-S2-Q12 FT 90 ILA-S2-Q12

Distance sensors
FR 91 ILA -S2-Q12 FT 91 ILA-S2-Q12

Reflex version Electrical data Supply voltage Residual ripple Power consumption Outputs Q1/Q2 Plausibility output Qp Service output Qs Protection class Short-circuit protection (all outputs) Polarity reversal protection Serial interface Bus interface Maximum cable length Analogue output Optical data Measuring ranges reflector (specified) black 6 % grey 10 % white 90 % Measuring laser Diameter of light spot Pilot laser Switching points Switching hysteresis Mechanical data Dimensions Weight Vibration/Shock Ambient operating temperature Storage temperature Protection Connection Housing material Measured values Resolution (output of measurement values) Repeatability Linearity Response time Temperature drift Thermal response Speed of measurement output
1) from

Proximity switch

Reflex version

Proximity switch

no

18 - 30 VDC 10 % within Ub < 4.5 W at 25 °Celsius 100 mA, PNP 50 mA, PNP (N.O.) 50 mA, PNP (N.O.) II double-insulated yes yes RS 422 or SSI - compatible (GRAY / BINARY) Profibus or DeviceNet via respective gateway (accessory) 100 m 4 - 20 mA no 4 - 20 mA

0.5 m ... 50 m 0.5 m ... 3 m 0.5 m ... 2 m 0.5 m ... 7 m 0.5 m ... 4 m 0.5 m ... 10 m 0.5 m ... 6 m IR 900 nm, laser protection class 1 20 x 20 mm @ 10 m 3 x 10 mm @ 4 m 20 x 20 mm @ 10 m 3 x 10 mm @ 4 m red 650 nm, laser protection class 2 adjustable in 1 mm steps min. 10 mm (adjustable) min. 20 mm (adjustable)

0.5 m ... 250 m

93 mm x 93 mm x 42 mm approx. 230 g EN 60947-5-2 -10 ... +50 °Celsius (-20 ... + 50 °Celsius in continuous operation) -30 ... +75 degrees Celsius IP 67 connector M16, 12 pin ABS shock-resistant

0.1 or 0.125 mm

0.1 or 0.125 mm

0.1 or 0.125 mm

0.1 or 0.125 mm

+/- 2 mm +/- 4 mm +/- 4 mm +/- 5mm +/- 3 mm 1) +/- 8 mm +/- 5 mm 1) +/- 10 mm 12 ms 12 ms 12 ms 12 ms < 0.5 mm/K < 0.5 mm/K < +/- 5 mm absolute < +/- 5 mm absolute SSI: 1,4 ms (SSI cycle 80 µs ; RS 422 2,9 ms at 57,6 kBaud)

2m All details regarding accuracy and distance are based on the specified surface at constant ambient conditions and with a minimum operating time of 15 minutes.

SensoPart Industriesensorik GmbH Phone +49 (0) 76 65 94 769-0, Fax +49 (0) 76 65 94 769-765 E-mail: info@sensopart.com www.sensopart.com

03/2006

068-13683