Page 41 of catalogue Actuator range of SKF Linearsysteme GmbH

Linear actuators Type key
Dynamic load (N)/Speed (mm/s) 4 000/xx 4 000/17-12 3 000/17-11 4 000/17-13 4 000/9-5 4 000/17-13 4 000/17-13 4 000/17-13 4 000/9-5 3 500/8 3 500/8 3 500/6,5 3 500/6,5 3 500/6,5 1 2 500/xx 2 500/32-25 2 000/34-19 2 500/33-24 2 500/18-10 2 500/33-24 2 500/33-24 2 500/33-24 2 500/18-10 2 500/16 2 500/16 2 500/13 2 500/13 2 500/13 2 1 500/xx 1 500/63-48 1 000/67-43 1 500/65-50 1 500/34-24 1 500/65-50 1 500/65-50 1 500/65-50 1 500/34-24 1 500/32 1 500/32 1 500/26 1 500/26 1 500/26 4 Motor options No motor 12 VDC, IP44 (65) 12 VDC, flat motor, IP44 24 VDC, IP44 (65) 24 VDC, low speed motor, IP44 24 VDC, flat motor, IP44 24 VDC, flat motor, brake, IP20 24 VDC, flat motor, ext.shaft, IP44 24 VDC, flat motor, low speed, IP44 120 VAC/60 Hz, 1-phase, IP54 120 VAC/60 Hz, 1-phase, brake, IP20 230 VAC/50 Hz, 1-phase, IP54 230 VAC/50 Hz, 1-phase, brake, IP20 400 VAC/50 Hz, 3-phase, IP55 0000 C12C D12C C24C C24CW D24C D24CB D24CS D24CW E110C E110CB E220C E220CB E380C

CAT
Type Motor assembly: Right Left Stroke (S): 50 mm 100 mm 200 mm 300 mm 400 mm 500 mm 700 mm 50700 mm contact SKF) Rear attachment (see page 42): Fork ear, =12,0 mm Fork ear, =12,7 mm Single ear, =12,0 mm Single ear, =12,7 mm Front attachment (see page 42): Hole, =12,0 mm Hole, =12,7 mm Male thread, M12 Female thread, M12 Fork ear, =10,1 mm Feedback No encoder (no code) Encoder (ony for CxxC Motors) Encoder (for all Standard motors) Options: Friction clutch No friction clutch Back-up nut Options for CxxC motors: No cable EMC filter Motor without cover IP65 (mandatory to state type of cable) Straight cable, 2,0 m, no plug Straight cable, 2,0 m, jack plug R L

32B X

X

/

50 100 200 300 400 500 700 --A1 A2 K1 K2 G1 G2 G3 G4 G5

E E2

F Z S U M N I T2 T2P

41